MFJ-269 SWR ANALYZER

1.8-170 MHz plus 415-470 MHz
New! HF/VHF/UHF SWR Analyzer Covers 1.8-170 MHz and 415-470 MHz . . . SWR . . . Complex RF Impedance: Resistance(R)
and Reactance(X) or Magnitude(Z) and Phase(degrees) . . . Coax cable loss(dB) . . . Coax cable length and Distance to fault . . . Return Loss . . . Reflection Coefficient . . . Inductance .
. . Capacitance . . . Battery Voltage. LCD digital readout . . . frequency counter . . . side-by-side meters . . . Ni-MH/Ni-Cad charger circuit . . . battery saver . . . low battery warning . . .
smooth reduction drive . . .
NEW MFJ-269

ÁÖÆļö : 1.8 - 170 MHz and 415 - 470 MHz -- an MFJ-269 exclusive! It includes all the features of the MFJ-259B, the world's most popular SWR Analyzer plus much more!
Large easy-to-read two line LCD display and side-by-side meters clearly display your information.
Built-in Ni-Cad/Ni-MH charger circuit, battery saver, low battery warning, smooth reduction drive tuning. Use as signal source for testing/alignment.
Built-in CoaxCalculator TM
-- calculates coax line length in feet given coax length in electrical degrees and vice versa for any frequency and any velocity factor (great for building matching sections and phasing lines) -- an MFJ-269 exclusive!

New 12-bit A/D converter gives much better accuracy and resolution than common 8-bit A/D
converters -- an MFJ-269 exclusive!
Super easy to use! Just set the bandswitch and tune the dial -- just like your transceiver.
1.8 to 170 MHz Range Features
MFJ-269 gives you a complete picture of your antenna. Read antenna SWR and Complex Impedance

1.8 to 170 MHz. Built-in frequency counter.
Read Complex Impedance as series equivalent resistance and reactance (Rs+jXs) or as magnitude (Z) and phase (degrees). Also reads parallel equivalent resistance and reactance (Rp+jXp) --
an MFJ-269 exclusive!
You can determine velocity factor, coax loss in dB, length of coax and distance to short or open in feet.

You can read SWR, return loss and reflection coefficient at any frequency simultaneously at a single glance. Also reads match efficiency.
Also read inductance in uH and capacitance in pF at RF frequencies.
You can measure SWR and loss of coax with any characteristic impedance from 10 to over 600 Ohms, including 50, 51, 52, 53, 73, 75, 93, 95, 300, 450 Ohms -- an MFJ-269 exclusive!
For more information see MFJ-259B, page 1.

New 415 to 470 MHz Range features
Just plug in your UHF antenna coax, set the frequency and read SWR, return loss and reflection coefficient simultaneously. You can read coax cable loss in dB and match efficiency.
You can adjust UHF dipoles, verticals, yagis, quads and other antennas and determine their SWR, resonant frequency and bandwidth.
You can test and tune stubs and coax lines.
You can manually determine velocity factor and impedances of transmission lines.
You can adjust and test RF matching networks and RF amplifiers without applying power.
Has easy-to-read LCD logarithmic SWR bar-graph and SWR meter for quick tuning.
Take it anywhere
Fully portable, take it anywhere -- remote sites, up towers, on DX-peditions. Built-in "N" connector. Free N-to-SO-239

 adaptor. Use 10 AA Ni-MH/Ni-Cad or alkaline batteries (not incl.) or 110VAC with MFJ-1315, $14.95. 4W x 2D x 63/4 H in.